PearTune Installation
PT-MSO-B2
① Remove the pedal arm using a proper equipment and the plastic cover of the centerdrive (using TORX screws) on the other side than the sprocket is located. All the needed cables and connectors are hidden under this cover.
② Disconnect the 4-position connector in between the display unit and motor unit (marked as DISPLAY on the picture) aswell as the 2-position connector in between the tacho sensor and motor unit (marked as SPEED SENSOR).
③ Connect both appropriate connectors from the MSO instead of the original connectors into the the motor unit and, the original, previously disconnected connectors into the MSO according to the color coding (red wire side onto the red wire side).
④ To keep the system waterproof, it is reccomended to use the heat shrinkable tubing on the both male MSO connectors connected into the original connectors from the tacho sensor and display unit. Place the MSO in a proper position and optionally, fasten the wiring using the electrical ties. Re-attach the plastic cover and pedal arm and the bike is ready to go.
Technical parameters
Dimension without wiring: 21 x 40 x 12mm
Supply voltage range: 5 - 15 V
Maximum current consumption: 100 mA
Maximum power usage: 1.5W
Mass: cca 30g
The voltage is lower then 20 V in all device and on I/O pins too