SpeedFun Furious Evo Easy+ for Rocky Mountain Dyname 4.0

SpeedFun Furious Evo easy+ for Rocky Mountain Dyname 4.0 is a revolutionary tuning kit which suppresses the speed limiter of your electric bike.

When the device is active, the display will show the exact speed up to the threshold of approximately 15 KmH, beyond which a manipulated speed will always be shown below 25 KmH.

The tuning kit manipulates the speed signal without altering the motor's power relative to pedaling speed. This guarantees a smooth motor control without speed limit interruptions. Depending on a tuning kit, some determine when assistance stops, while others remove the restriction entirely for continuous support. However, the achievable speed mostly depends on the eBike model. Achievable speed can be calculated using a simple formula:

Speed = Cadence [rpm] * Wheel circumference [mm] * Front Chainring Teeth / Rear Chainring Teeth * 60 [min/h] / 1.000.000 [mm/km]

After installation, your tuning kit will be activated with the activation of your eBike. Maximum speeds of ~30mph (50km/h) or even faster can be expected, depending on the bike and gearing.

This speed unlocker is compatible with Rocky Mountain Dyname 4.0 motors from 2022 equipped with a 720Wh Powerplay battery and Jumbotron display.

Ebike with Rocky Mountain Dyname 4.0 motor where the Furious Evo easy+ device has been successfully installed (this list is illustrative and not exhaustive)

– Altitude Powerplay Carbon 90 Rally Edition
– Altitude Powerplay Carbon 70
– Altitude Powerplay Alloy 70
– Altitude Powerplay Alloy 50
– Altitude Powerplay Alloy 30 Coil
– Instinct Powerplay Carbon 90
– Instinct Powerplay Carbon 70
– Instinct Powerplay Alloy 70
– Instinct Powerplay Alloy 50
– Instinct Powerplay Alloy 30

When connecting Tuning Kit to an e-bike you will find connectors colored to make installation very simple. We have prepared detailed instructions and videos to make installation easy for you. Disassembly of our tuning kit is just as easy. If you have any troubles with installation or disassembly, do not hesitate to contact us. If you are planning to install Speedfun on a brand-new bike, make sure you ride it for at least 0.6 miles (1 km) before the tuning kit is activated.

Please note that the operation of this type of modified electric bikes on public roads may be against the law in some countries. The manufacturer takes no responsibility for damages resulting from the use SpeedFun products. Electric bikes equipped with SpeedFun products are not allowed to be used on public roads, cycling paths and public places. Electric bikes equipped with SpeedFun products can be used exclusively on private property and entirely at one’s own risk.

The use of SpeedFun may void the warranty of your ebike. We strongly recommend using other safety features and protective gear to prevent injuries in higher speeds.

Warranty does not cover damage resulting from eBike software updates. Remove the tuning kit before updating the software. Check with us first to ensure the kit is compatible with your updated eBike. We cannot guarantee that the kit will function the same after updates. Please exercise caution.