SpeedFun Furious for Fazua Ride 50

SpeedFun FURIOUS for Fazua Ride 50 is a revolutionary tuning kit which suppresses the speed limiter of your electric bike.

After installing your SpeedFun, your e-bike’s display will show real data up to 12mph (20km/h) - at higher speeds, the display will show half speed and relative data making it possible, by simply multiplying in mind by two, the calculation of the actual speed and miles or kilometers traveled.

The motor's electric assistance switches off when reaching 30mph (50km/h).

The tuning kit manipulates the speed signal without altering the motor's power relative to pedaling speed. This guarantees a smooth motor control without speed limit interruptions. Depending on a tuning kit, some determine when assistance stops, while others remove the restriction entirely for continuous support. However, the achievable speed mostly depends on the eBike model. Achievable speed can be calculated using a simple formula:

Speed = Cadence [rpm] * Wheel circumference [mm] * Front Chainring Teeth / Rear Chainring Teeth * 60 [min/h] / 1.000.000 [mm/km]

After installation, your tuning kit will be activated with the activation of your eBike. This tuning kit can be activated / deactivated also, but only by your choise, you do not need to do it everytime you turn On ebike.

Activation and deactivation:
- Turn the ebike off and on again. Do not move it or do other operations.
- Raise the rear wheel, give a strong pedal with the longest (hardest) gear engaged.
- Let it run for a few seconds.
- The system recognizes the acceleration and considers it as an activation or deactivation command (cyclically). Upon activation, the display shows the speed that change from real to halved in the manner described above. When deactivated, the display shows the speed change from halved to real and the bike returns to its original state.

This tuning kit is compatible with eBikes that have Fazua Ride 50 Motor. And it works with any type of display.

ATTENTION!
This device is not compatible with Fazua Ride 60 motors. The product compatible with Fazua Ride 60 motors is available Here

Ebike with Fazua Ride 50 motors where the Tuning Kit was successfully installed and tested:
- Pinarello Nytro E-Road Bike
- Lombardo E-Mugello Road
- Cube Agree Hybrid C:62
- Whistle Flow, Bianchi E-Doardo
- Fantic Passo Giau
- Focus Project Y
- Maserati MC Corse
- Atala E-Road Flow
- Bottecchia BE 90 Pulsar E-Road carbon
- Focus Raven 2
- Whistle E-Road Flow
- Cairn e-bike
- Focus Paralane² e-road and Boardman ADV 8.9E Adventure Electric Bike.

When connecting the SpeedFun chip to an eBike you will find connectors colored to make installation very simple. We have prepared detailed instructions and videos to make installation easy for you. Disassembly of our tuning chip is just as easy. If you have any troubles with installation or disassembly, do not hesitate to contact us.

Installation Guide:

Please note that the operation of this type of modified electric bikes on public roads may be against the law in some countries. The manufacturer takes no responsibility for damages resulting from the use SpeedFun products. Electric bikes equipped with SpeedFun products are not allowed to be used on public roads, cycling paths and public places. Electric bikes equipped with SpeedFun products can be used exclusively on private property and entirely at one’s own risk.

The use of SpeedFun may void the warranty of your ebike. We strongly recommend using other safety features and protective gear to prevent injuries in higher speeds.

Warranty does not cover damage resulting from eBike software updates. Remove the tuning kit before updating the software. Check with us first to ensure the kit is compatible with your updated eBike. We cannot guarantee that the kit will function the same after updates. Please exercise caution.